5 Litres

Majic Stone Tel: 02 9816 4555 Fax: 02 9817 8555
250 Victoria Road Gladesville NSW 2111

Not to be taken
Keep out of reach of children
Read Safety directions before opening

PERFORMANCE WARRANTY
Majic warrants Paver-Seal to perform as stated when applied exactly as directed.

PAVER-SEAL is a water-based surface sealer that provides a mat to gloss finish. It protects against staining for porous tile, paving, stone and grout including; concrete, terracotta tile, cast stone, paving, sandstone, limestone, slate, brick and cement grout.
HOW TO USE: 1. ALWAYS TEST PRODUCT ON A SMALL AREA FIRST. Allow a 24-hour cure time to determine the ease of application and desired results. 2. Remove and repair all loose or missing grout. 3. Ensure surfaces to be treated are dry, clean and free of residues. 4. Apply when the surface temperature is between 5 and 35 deg C. Generously saturate the surface with product using a clean brush, or similar. Avoid contact with surrounding areas. Application rate is approximately 1 litre per 2.5 to 10 square metres, depending on porosity. 5. Allow 10 minutes for product to soak in then buff surfaces with a clean white dry cloth to remove excess product. 6. Clean brush in water. 7. Let the product dry for a minimum of 12 hours before using the surface. 8. For a glossier look, after 12 hours, repeat application over entire area. 9. Clean-up stains immediately to minimise absorption. PRECAUTIONS: Do not take internally. Avoid contact with skin and eyes. Avoid breathing vapours. Wear protective eye goggles, gloves and clothing. Ensure area is well ventilated. Keep away from naked flames and ignition sources. FIRST AID: If ingestion occurs, contact doctor or Poisons Information Centre (Australia-phone 131126). INDUCE VOMITING. Give a glass of water. After eye or skin contact wash off immediately with plenty of water. STORAGE: Keep container tightly sealed, in a cool well-ventilated place. TRANSPORT: UN No: Non Regulated, HAZCHEM: Non Regulated. MADE IN AUSTRALIA